Does your car stall while driving, or does the engine crank but won't start? The crankshaft position sensor, also called the crank sensor or CKP sensor, may be to blame. This 90-second video shows where it is and why the engine can't run without it.
What does a crankshaft position sensor do?
The crankshaft position sensor is mounted low on the engine, facing a toothed ring that turns with the crankshaft. Each time a tooth passes, it sends a pulse. That way, the engine control unit knows the engine speed and exactly where the pistons are: it uses this signal to decide when to inject fuel. Without it, the control unit no longer knows when to inject, and the engine won't run.
Bad crank sensor: the symptoms
With heat and vibration, the sensor eventually weakens. The problem is often intermittent:
- the engine stalls while driving, sometimes without warning;
- the engine cranks but won't start;
- it mostly happens when the engine is hot, then everything works again once it has cooled down.
Which fault codes point to the crankshaft position sensor?
The engine control unit stores a fault code, but the check engine light doesn't always come on. The most common is P0335: a problem in the sensor's circuit. With P0336, the signal does come through, but it doesn't make sense.
| Code | Meaning |
|---|---|
| P0335 | Crankshaft Position Sensor "A" Circuit Malfunction |
| P0336 | Crankshaft Position Sensor "A" Circuit Range/Performance |
How do you know if the crank sensor is bad?
- Watch the tachometer while the starter is cranking: if it stays at zero, the sensor's signal is probably missing.
- Check the sensor's connector: pushed all the way in, and clean.
- Inspect the wire: not cut, not damaged.
- Replace the sensor only after these checks.
Can you drive with a failing crankshaft position sensor?
Better not: without its signal, the engine shuts off. A failing sensor can make the car stall anywhere, including in the middle of traffic. Have the fault codes read and the problem fixed before getting back on the road.
Read the full video transcript
Does your car stall while driving, or does the starter crank but the engine won't start? Take a look at this part.
This is the crankshaft position sensor, also called the crank sensor. It's mounted low on the engine, facing a toothed ring that turns with the crankshaft.
Each time a tooth passes, the sensor sends a pulse. That way, the engine control unit knows the engine speed and exactly where the pistons are. Without this signal, the control unit no longer knows when to inject.
With heat and vibration, the sensor eventually weakens. It often fails when hot, then works again once it has cooled down. The engine stalls, or won't start at all.
The engine control unit then stores a fault code. The check engine light, however, doesn't always come on. The most common one is P0335: a problem in the sensor's circuit. With P0336, the signal does come through, but it doesn't make sense.
A simple test: while the starter is cranking, watch the tachometer. If the needle stays at zero, the signal is probably missing. Then check the sensor's connector and wire, before replacing the sensor.