Is your engine hard to start, does it sometimes stall while driving, or refuse to restart when hot? The camshaft position sensor may be to blame. This 90-second video shows where it is and what it does.
What does a camshaft position sensor do?
The camshaft position sensor, also called the cam sensor or CMP sensor, is a small sensor usually mounted at the top of the engine, on the cylinder head, facing the camshaft. The camshaft controls when the valves open: the sensor tracks its position on every turn. Together with the crankshaft position sensor, it lets the engine control unit know which cylinder is ready, so fuel is injected at the right moment.
Bad camshaft position sensor: the symptoms
With heat, its electronics eventually give out. Sometimes, oil seeps into its connector. The signal becomes wrong, or disappears:
- the engine is hard to start, or slower to start;
- it sometimes stalls while driving;
- it won't restart after a stop, especially when hot.
Which fault codes point to the camshaft position sensor?
The engine control unit stores a fault code, but the check engine light doesn't always come on. The most common is P0340: a problem in the sensor's circuit. With P0341, the signal does come through, but it doesn't make sense.
| Code | Meaning |
|---|---|
| P0340 | Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) |
| P0341 | Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1) |
What to check before replacing the sensor?
- Start with the sensor's connector: clean, dry, pushed all the way in, with no trace of oil.
- Inspect the wiring harness: a chafed wire sets exactly the same code.
- Then replace the sensor: it's usually easy to change.
- If the code still comes back, have the timing belt or chain checked at a repair shop.
Can you drive with a bad camshaft position sensor?
Often yes, carefully: many engines start and run without this sensor, with longer cranking and sometimes reduced power. But the engine can also stall or fail to restart: don't go far, and have it checked soon.
Read the full video transcript
Is your engine hard to start? Does it sometimes stall while driving, or refuse to restart when hot? Take a look at this part.
This is the camshaft position sensor. It's a small sensor, usually mounted at the top of the engine, on the cylinder head, facing the camshaft.
The camshaft controls when the valves open. The sensor tracks the camshaft's position on every turn. Together with the crankshaft position sensor, it lets the engine control unit know which cylinder is ready, so fuel is injected at the right moment.
With heat, the sensor's electronics eventually give out. Sometimes, oil seeps into its connector. The signal becomes wrong, or disappears: the engine is hard to start, stalls, or won't restart after a stop.
The engine control unit then stores a fault code. The check engine light, however, doesn't always come on. The most common one is P0340: a problem in the sensor's circuit. With P0341, the signal does come through, but it doesn't make sense.
Start with the sensor's connector: it should be clean, dry, pushed all the way in, with no trace of oil. The sensor itself is usually easy to replace. If the code still comes back, have the timing belt or chain checked at a repair shop.