Do you smell gasoline around your car? It's not necessarily a fuel leak: the charcoal canister system may be to blame. This 90-second video shows what it does, and why the gas cap is often the culprit.
What does the charcoal canister do?
The charcoal canister is a box filled with activated charcoal, mounted near the gas tank. Hoses connect it to the tank, to the outside air and to the engine's intake. Inside the tank, gasoline evaporates: the canister traps these vapors so they don't escape into the air. With the engine running, a purge valve draws them into the engine, which burns them. This system is called the EVAP system, which is why the part is also known as the EVAP canister.
Bad canister or EVAP leak: the symptoms
To test the system, the engine control unit seals it off, then checks that the pressure holds. If air gets in somewhere, it detects a leak:
- often, you won't notice anything;
- sometimes, a gas smell around the car.
This system is found on gasoline engines: on a diesel, these codes are rare.
What do codes P0455 and P0442 mean?
The engine control unit stores a fault code, but the check engine light doesn't always come on. With P0442, the leak is small. With P0455, it's large: very often, it's simply the gas cap.
| Code | Meaning |
|---|---|
| P0455 | Evaporative Emission System Leak Detected (Large Leak) |
| P0442 | Evaporative Emission System Leak Detected (Small Leak) |
Did the code show up right after filling up? That's very common: the gas cap wasn't closed properly, or the tank was topped off after the pump clicked off. Tighten the cap and drive a few trips: the code may go away on its own.
What to check before replacing the canister?
- Start with the gas cap: tightened properly, with its seal in good condition.
- Then check the hoses in the system.
- Check the purge valve.
The canister itself rarely needs replacing.
Read the full video transcript
Do you smell gasoline around your car? It's not necessarily a fuel leak. Take a look at this part.
This is the charcoal canister. It's a box filled with activated charcoal, mounted near the gas tank. Hoses connect it to the tank, to the outside air, and to the engine's intake.
Inside the tank, gasoline evaporates. The canister traps these vapors so they don't escape into the air. With the engine running, a purge valve draws them into the engine, which burns them.
To test the system, the engine control unit seals it off, then checks that the pressure holds. If air gets in somewhere, the control unit detects a leak. Often, you won't notice anything; sometimes, there's a smell of gasoline.
The engine control unit then stores a fault code. The check engine light, however, doesn't always come on. With P0442, the leak is small. With P0455, it's large: very often, it's simply the gas cap.
So start with the gas cap: properly tightened, with its seal in good condition. Then check the hoses, and then the purge valve. The canister itself rarely needs replacing.