Is your car using more fuel than before for no reason, or did it fail its emissions test? The oxygen sensor, also called the O2 sensor or lambda sensor, may be to blame. This 90-second video shows where it is, what it does and how it wears out.
What does an oxygen sensor do?
The oxygen sensor is screwed into the exhaust, like a spark plug, with a wire running up to the engine control unit. Most cars have two: one before the catalytic converter (upstream sensor) and one after it (downstream sensor). It measures the oxygen left in the exhaust gases: too much oxygen means the mixture is too lean; not enough means it's too rich. Thanks to this sensor, the engine control unit adjusts the fuel injection several times per second.
Bad O2 sensor: the symptoms
Over time, the sensor gets dirty and becomes slow: the engine control unit corrects too late. The most common signs:
- higher fuel consumption;
- a rough idle;
- excessive emissions at inspection.
The check engine light often comes on, but not always right away: reading your car's fault codes is still the surest way to know.
How do you know if the oxygen sensor is bad?
The most common code is P0135: the sensor's heater has failed. P0133 means it responds too slowly.
| Code | Meaning |
|---|---|
| P0133 | O2 Sensor Slow Response (Bank 1, Sensor 1) |
| P0135 | O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1) |
| P0171 | System Too Lean (Bank 1) |
With P0171, be careful: often, it's not the sensor. It's only reporting an air leak, which you need to look for elsewhere. And each code points to a specific sensor (“sensor 1” for upstream, “sensor 2” for downstream): there's no need to replace both.
What to check before replacing the oxygen sensor?
- Check the connector and the wire: they're often damaged by heat.
- Look for an exhaust leak: it throws off the reading.
- To replace it, unscrew it with the engine warm, using an oxygen sensor socket, without ever touching its tip.
Can you drive with a bad oxygen sensor?
Yes, with no immediate danger: the engine runs, but the mixture is less well controlled and fuel consumption may go up. In many countries and US states, a lit check engine light means a failed inspection or emissions test.
Read the full video transcript
Is your car using more fuel than before, for no reason? Did it fail its emissions test? Take a look at this small sensor.
This is the oxygen sensor. It's screwed into the exhaust, like a spark plug, with a wire running up to the engine control unit. Most cars have two: one before the catalytic converter, and one after.
It measures the oxygen left in the exhaust gases. Too much oxygen means the mixture is too lean. Not enough means it's too rich. Thanks to this sensor, the engine control unit adjusts the fuel injection several times per second.
Over time, it gets dirty and becomes slow. The engine control unit corrects too late. The result: higher fuel consumption, a rough idle, and excessive emissions at inspection.
The check engine light comes on. The most common code is P0135: its heater has failed. Here, it's P0133: the sensor responds too slowly. And with P0171, be careful: often, it's not the sensor. It's just reporting an air leak.
Before replacing it, check the connector and the wire, often damaged by heat, and look for an exhaust leak: a leak throws off the reading. To replace the sensor, unscrew it with the engine warm, using an oxygen sensor socket, without ever touching its tip.