Car part of the day · Episode 15

Bad knock sensor: symptoms and code P0325

Is your engine knocking going uphill, lacking power, or using more fuel than before? The knock sensor may be to blame. This 90-second video shows where it is and how it protects the engine.

What does a knock sensor do?

The knock sensor is bolted to the side of the engine block, level with the cylinders. It works like a microphone: it listens to the engine's vibrations. When the mixture explodes instead of burning, that's engine knock, also called pinging: a metallic knocking that can damage the engine. The sensor hears it, and the engine control unit retards the ignition timing to protect the engine.

Bad knock sensor: the symptoms

When the sensor comes loose, or its wire is damaged, it can't hear anything anymore. To be safe, the engine control unit then keeps the ignition retarded all the time:

  • a loss of power;
  • higher fuel consumption;
  • sometimes an engine that knocks going uphill, if knock is no longer detected.

What does code P0325 mean?

The engine control unit stores a fault code, but the check engine light doesn't always come on. The most common is P0325: a problem in the sensor's circuit. With P0328, its signal is too high.

CodeMeaning
P0325Knock Sensor 1 Circuit Malfunction (Bank 1)
P0328Knock Sensor 1 Circuit High Input (Bank 1)

What to check for code P0325?

  1. Check the sensor's connector and wire: connector pushed all the way in, wire intact.
  2. Check how tight it is: it must be tightened to the correct torque; too tight or too loose, it can't hear properly.
  3. Use the fuel recommended by the manufacturer: an octane rating that's too low makes knock more likely.

Can you drive with a bad knock sensor?

Most of the time, yes, carefully: the engine control unit plays it safe by retarding the ignition, at the cost of less power and higher fuel consumption. Avoid pushing the engine on hills, and have it repaired before too long.

Read the full video transcript

Does your engine knock going uphill, lack power, or use more fuel than before? Take a look at this part.

This is the knock sensor. It's bolted to the side of the engine block, level with the cylinders.

It's a kind of microphone: it listens to the engine's vibrations. If the mixture explodes instead of burning, that's engine knock. The sensor hears it, and the engine control unit retards the ignition to protect the engine.

When the sensor comes loose, or its wire gets damaged, the sensor can't hear anything anymore. To be safe, the engine control unit then keeps the ignition retarded all the time: the engine loses power and uses more fuel.

The engine control unit then stores a fault code. The check engine light, however, doesn't always come on. The most common one is P0325: a problem in the sensor's circuit. With P0328, the sensor's signal is too high.

First, check the sensor's connector and wire. The sensor must be tightened to the correct torque: too tight or too loose, it can't hear properly. And use the fuel recommended by the manufacturer: an octane rating that's too low makes knock more likely.